>> Learn More
>> Home

Inexpensive Black Mold Testing Kit: Results Available In 24 Hours

Mold in Your Home

If you see black mold in your home, DO NOT panic! A number of molds can sometimes be found growing in houses on drywall, wood, behind wallpaper, and on ceiling tiles in areas that are constantly moist or have suffered water damage or leaks. Some of these molds such as Stachybotrys, Aspergillus and Penicillium are associated with adverse health effects. Others like Alternaria and Cladosporium are well known allergens that trigger allergic reactions to sensitized individuals.

BUT, not all black molds that occur indoors are hazardous. Also, some dangerous molds are not black. However, current Canadian mold guidelines advise building occupants to clean-up and/or remove visible mold growth. To control mold growth, moisture should be eliminated or reduced.

If you see mold growth, you may submit tape samples to determine whether the mold present is hazardous or only a cosmetic concern. A tapelift sample is the most inexpensive test (see prices on our Order form), and from it MBL can give you information and guidance on what to do next. It is an easy way to determine if the mold is toxic and if it will require more intensive investigation and remediation. Cleaning hazardous mold requires special protection.

How Do You Take Mold Samples?

It is easy. We will send you an easy-to-use mold sampling kit with clear instructions for use. The MOLD TAPE SLIDE™ is a straightforward and effective method to sample visible mold found on any surface. To request your kit, download our order form. If you are not able to print the form, just call 1-866-813-0648 to place an order over the phone.


How To Take Tape Samples For Mold Testing

• Wear suitable gloves. If you are likely to disturb the mold, you should also wear a mask.
• Record the sample number on the slide label. For example:
  • Sample #1 or Tape #1.
• Peel off seal from slide to expose adhesive (see the words "Peel Here")
• Place sticky side of slide onto the surface with visible mold growth and press gently.
• Place slide back into plastic snap-case.
• Repeat the same procedure for any other sample you wish to take.
• Once you have taken all the samples, complete the Mold Analysis Request Form. Provide information on where the samples were collected, for example:
  • Tape #1: Basement, east wall
  • Tape #2: Windowsill, master bedroom
  • Tape #3: Ceiling tile, bathroom
  • Tape #4: Under counter, kitchen sink.
• Enclose samples in an envelope for sending by post or courier.

(NOTE: More than one mold type may be present. If several sites show visible mold growth, it is advisable to take more than one sample.)



Other Suitable Samples For Mold Testing

Did you know?
You can also send pieces of wallpaper, drywall, wood, carpet, insulation material, dust or any other material for mold testing.


Sending the Samples

To send your samples, download our Mold Analysis Request Form. If you can't print the form just provide the required information on a sheet of paper and send it together with your samples.

Submit the samples together with the following information:

• Name
• Address
• Phone
• Fax (if available)
• Email address
• The date the sample was collected

If you have any questions, call 905-290-9101. You may pay by credit card (Visa or MasterCard) or by cheque. Mail or deliver samples to:



Questions? contact us or use our LiveHelp feature (when online)!


>> Learn More
>> Home